User's Manual

Other Remote Start Features (cont’d)

It is typically recommended that vehicles equipped with turbocharged engines allow

the engine to idle after driving to cool the turbocharger. When Installer Programmable

Feature #10 is ON, the system will automatically keep the engine running as follows:

• Withtheenginerunning,holdthebrakepedalandengagetheparking

brake. When the brake pedal is released, the system will keep the engine running for

the programmed time (1, 2, or 3 minutes), and then automatically turn it off.

• Thesystemmaybelockedwhiletheengineisrunning.TurboTimercanbe

prevented from engaging, or “bypassed” if desired, by turning the engine off before

engaging the parking brake, or if it’s already engaged, step on the brake pedal to turn

the engine off.

TURBO TIMER FEATURE

PIT-STOP FEATURE

This feature allows you to leave your engine running for making quick errands. To

use this feature, have the engine running normally from the ignition switch and your

footoffthebrakepedal.PresstheValetSwitchtwice;theparkinglightswillashand

the horn will chirp 5 times. Turn the key off and the engine will remain running for the

programmed run time.

MANUAL TRANSMISSION STARTING

Remote starting with a manual transmission requires a different installation method

and installer feature #11 must be turned on. Also, a setup procedure that ensures the

transmission was left in neutral must be performed each time you leave your vehicle

and intend to use remote start later. Perform these steps:

1) With the engine running, hold the brake pedal, apply the parking brake, then

release the brake pedal.

2) Use the transmitter as if you were activating remote start (default: press START

twice).Thegreenstatuslightwillstarttoashslow.

3) Turn off the ignition key and exit the vehicle.

4) Press LOCK on the transmitter. The engine will shut down (unless turbo timer is

on)andthestatuslightwillashgreenevery2secondstoindicateitisreadytobe

remote started.

NOTE: Manual transmission starting is canceled if you enter the vehicle after

performing the setup procedure.

LAST DOOR ARMING

 Thissystemcanbeconguredtoarmautomaticallywhenallthevehicle’sdoors

are closed (see user feature #9). When this feature is utilized, the siren/horn will chirp

once when all of the doors are closed. At that point, it will start a 30 second count-

down(indicatedbyafastashingstatuslight).After30seconds,thesystemwillarm

(andlockthedoorsifconguredtodoso).Duringthe30secondarmingdelay,ifa

point of entry is opened, the countdown will pause until all entry points are closed

again. Turning ON the ignition key will cancel the last door arming sequence until the

key is turned off and the doors are all closed once again.

Security System Features