User's Manual

Controller & Transmitter Functions (cont’d)
AUXILIARY FUNCTIONS 1-4:
The actual operation of these functions will vary from car to car. They are designed
to operate extra vehicle functions like automatic sliding doors or motorized hatches.
Aux 1-4 are virtual outputs only available on certain vehicles when this system is
integratedwiththevehicle’sdatanetwork.Consultwithyourinstallertondoutifany
ofthesefunctionsareavailableforyourvehicle.Ifso,conrmeachoperationwiththe
controller and write each function in the blank spaces provided below.
- Auxiliary 1 Function (___________________): To activate this function, press
and release the “trunk” and “start” buttons simultaneously).
- Auxiliary 2 Function (___________________): To activate this function, press
and release the “lock” and “trunk” buttons simultaneously).
- Auxiliary 3 Function (___________________): To activate this function, press
and release the “unlock” and “start” buttons simultaneously).
- Auxiliary 4 Function (___________________): To activate this function, press
and release the “unlock” and “trunk” buttons simultaneously).
LOW BATTERY/LOW TEMP AUTOMATIC STARTING
Other Remote Start Features
REMOTE VALET: Press “LOCK” then “UNLOCK” then “TRUNK” +
“START” within 5 seconds.
• THE SYSTEM WILL ENTER VALET MODE.
SEE PAGE 10 FOR MORE INFO ON VALET MODES.
• UPON RECEIVING CONFIRMATION FROM YOUR SYS-
TEM, THE CONTROLLER WILL SHOW THE VALET ICON.
TO EXIT VALET VIA REMOTE, REPEAT THESE STEPS
This feature will automatically start the engine if the vehicle battery drops below 11
volts or the interior temperature drops to 15 (or 32) degrees fahrenheit. You must ac-
tivate these features each time you park your car to use them. They can be activated
one of two ways:
Method 1 - Valet Switch
• Turntheignitionswitch“on”,then“off”(enginenotrunning),andwithin7seconds
press the valet switch twice. If there is a 2 second delay without additional valet but-
ton presses, the horn will honk 3 times activating low voltage start mode.
• Toactivatelowtempstarting,enterlowvoltagestartmodeasdescribedabove
then, immediately after the horn honks, press the valet switch 1 time (15 degrees) or
2times(32degrees)within5seconds.Thehornwillhonktoconrmyourselection.
Method 2 - With The Controller (Low Volt + Low Temp - 15 Degrees Only)
• Within5secondsofpressingLOCK,presstheSTARTbutton.Youwillgetonechirp
and the 2-way controller will alternate between “ARM” and “RS AUTO”.
NOTE: When low temp start mode is activated, low voltage start is also activated.
These features will operate once every two hours until the ignition key is
turned “ON”.
1
2
3
7