User's Manual

Controller & Transmitter Functions (cont’d)
CHANNEL 3: Press and hold the “TRUNK” & “START“ buttons for 3
seconds.
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 3
OUTPUT.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL SHOW “CH3” ON
THE CLOCK DISPLAY.
CHANNEL 4: Press and hold the “LOCK” & “TRUNK” buttons for 3
seconds.
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4
OUTPUT.
• THERE IS NO 2-WAY CONFIRMATION FOR THIS
FUNCTION.
The engine will run for the preset run time (see user feature #1).
• Run Time Extender: Press the “START” button one time during remote start
to restart the engine run timer. The timer will restart at “0:00”.
NOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
• If you decide not to drive your vehicle, you can turn off the remote start using
the same method to turn it on (Default = press “START” twice in 5 seconds).
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to
the “ON/RUN” position (NOT START!!). When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over.
seconds.
CHANNEL 5: Press and hold the “UNLOCK” & “START“ buttons for
3 seconds
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5
OUTPUT.
• THERE IS NO 2-WAY CONFIRMATION FOR THIS
FUNCTION.
5