User's Manual

Using The Valet Switch

SECURECODE

SecureCode allows you to customize the number of valet presses required to per-

form an emergency override. This is an extra layer of security that prevents anyone

from overriding the alarm even if they have a key to the vehicle. SecureCode has 2

stageswiththerstrequiring1-9buttonvaletpressesandthesecondrequiring0-9

valet button presses. This gives you 99 possible combinations. To program a custom

SecureCode, please refer to user feature #13 on Page 18.

To perform an emergency override with SecureCode, use the following steps:

STEP 1 - With the system armed, enter the vehicle (the alarm will activate).

STEP 2 - Turn the ignition switch to the “ON” position.

STEP 3 - Within5secondsofstep2,pressthevaletswitchtoentertherstdigitof

your programmed code.

STEP 4 - Afterafewseconds,thesirenwillstopsoundingandchirponce(conrming

stage 1). The siren will then continue sounding.

STEP 5 - Now, within 5 seconds of step 4, press the valet switch to enter the second

digit of your code. If the code is correct, the alarm will disarm.

If the code is entered incorrectly, you must turn the ignition key OFF, then back

ON to try again. Additionally, if 2 failed attempts are made, the alarm will ignore any

further attempts for 2 minutes.

VALET MODE

Valet mode completely disables all security & remote start functions. Keyless entry

is still operable. To enter valet mode, perform the following steps:

STEP 1 - Disarm the system by remote or by performing an emergency override.

STEP 2 - Press and hold the valet switch for 2 seconds. The system will chirp once

and the status light will turn on.

EXITING VALET MODE - Press and release the valet switch once. The status light

will turn off.

EMERGENCY OVERRIDE

If you were to lose or break your controller, you’d need to perform an emergency

override to disarm the system and use your vehicle. To do so, use the following steps:

STEP 1 - Enter the vehicle (the alarm should sound).

STEP 2 - Turn the ignition key to the “ON” position.

STEP 3 - Press the valet switch (located in the window-mount antenna) once.

NOTE: Enter your SecureCode at this time if programmed via user feature #13

STEP 4 - Turn the ignition key “OFF”.