User Manual

22870433

MANUAL

1. Power On Status: All function Off

2. Learn-in Code:

1. Turn IGNITION OFF to ON (open for 15 seconds)

2. Press VALET SW.OFF/ON 3 times, LED ON turned on

and activate learn-in-Code MODE.

2.1 Press Btn”1” to learn the first TX.

2.2 ---- Horn 20ms, one Beep, Press LED OFF/ON once.

2.3 Other Keys automatically activated.

2.4 Back to 2.2.1 learn the next TX, up to 4 TX code.

3. Turn IGN ON to OFF, or 15seconds time-out, ending learn-in-code process: LED OFF

3. Common TX function

4. FEATURE PROGRAM: ★★: RED part is Default Setting

4.1 IGN OFF TO ON (open for 15 Sec),VALET SW ON/OFF(6 times), finished in 15 Sec.

4.2 Chirp 6 Beep, LED ON, proceed Setup, as below circumstance

4.3 IGN OFF shutdown FEATURE Mode, Horn Chirp 1 short-sound 1long-sound

4.4 FEATURE TABLE

5. D/HT Function: Dimming Time 5 sec

5 -1. Door Open / Close = D/HT On 20 sec, then Dimming .

5 -2. Remote Door Unlock = D/HT On 30 sec, then Dimming .

5 -3. Ext Car Remote Lock The Door then Dimming

5-4. Ign On D/HT Off then Dimming

PAGE 1
22870433 MANUAL 1. Power On Status: All function Off 2. Learn-in Code: 1. Turn IGNITION OFF to ON (open for 15 seconds) 2. Press VALET SW.OFF/ON 3 times, LED ON turned on and activate learn-in-Code MODE. 2.1 Press Btn”1” to learn the first TX. 2.2 ---- Horn 20ms, one Beep, Press LED OFF/ON once. 2.3 Other Keys automatically activated. 2.4 Back to 2.2.1 learn the next TX, up to 4 TX code. 3. Turn IGN ON to OFF, or 15seconds time-out, ending learn-in-code process: LED OFF 3. Common TX function 4.
PAGE 2
2870433 MANUAL GOVERNMENT REGULATIONS This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.