Installation Instructions

2022-03-31
To program a personal pin code:
The user can assign a 5-digit secondary password.
Note: Keypad must be paired to a DS4 before entering the secondary code.
1. Enter configuration mode by pressing and holding buttons 1/2, 3/4 and 9/0, indicated by three
blinks of backlight.
2. Enter the master code.
3. Press and hold button 3/4 to enter user code mode, indicated by three blinks of transmit LED.
4. User has five seconds to enter new code.
Note: Each press will give the user five seconds to enter the next key.
If successful, backlight will blink four times and the keypad will go to sleep in two seconds. If
timeout occurs, backlight will quickly blink two times, and then slowly two times, and the
keypad will go to sleep in two seconds.
To delete a personal pin code:
1. Enter configuration mode with a press and hold of buttons 1/2, 3/4 and 9/0, indicated by three
blinks of backlight.
2. Enter the master code.
3. Press and hold button 3/4 to enter user code mode, indicated by three blinks of small LED.
4. Wait five seconds for the code to be deleted.
After five seconds, backlight will quickly blink twice, two times slowly, and keypad will go to
sleep in two seconds. User code has been cleared.
Anti-Scan mode
The keypad will allow:
• Three attempts to enter the 5-digit code correctly or sixteen button presses
• One button press to wake-up the keypad from “sleep mode”
• Three attempts to enter the 5-digit code correctly
If all three attempts fail to enter the correct 5-digit code (master code or personal code), the keypad will
activate “Anti-Scan/Lockout Mode” for one minute, disabling the keypad unlock functions.