Owner's Manual

To replace the transmitter battery ;

1. Remove the small phillips head screw from the bottom

of the transmitter.

2. Use a small screwdriver or coin in the slot at the top

edge of the transmitter, and carefully unsnap the top cover

of the transmitter away from the bottom cover.

3. Remove the discharged battery, making note of the

location of the ( + ) and ( - ) contacts, and replace with a

new 12 volt type GP 23A battery.

4. Be sure the Red banic button is properly placed on the

back cover of the transmitter as shown.

5. Lift the rubber boot off of the circuit board, and press it

in place in the track surrounding the panic button. This

will help to hold the panic button in place.

6. Carefully snap the two transmitter halves back together,

then secure with the small phillips head screw.

REPLACING the BATTERY