User's Manual

Starting Your Vehicle with the 2-Way:

The remote control start function is activated by pressing the button two times

within 3 seconds on either the 2-way remote control transmitter. If you are within the

operating range of the system, your transmitter will respond with one single beep and

one ﬂ ash of the blue LED behind the button. This response indicates that the

signal to start was received by the system. Once the vehicle starts (1-3 seconds later),

your 2-way transmitter will respond with 2 beeps and 2 ﬂ ashes of the blue LED. While

remote started, the blue LED will continue to ﬂ ash every few seconds indicating the

vehicle is still running via remote start.

Note: See the vehicle’s owner manual for further remote start run time details.

Stopping Your Vehicle:

Press and hold** the button to turn off the vehicle. When the remote start is shut

down by any means (run time has expired, by remote control, gear shifter actuated,

hood opened), and you are within the operating range of the system, your 2-way

transmitter will respond with 3 beeps and 3 ﬂ ashes of the blue LED, indicating the

remote start system has turned off. If you are out of the system operating range at

the time of remote start shutdown, your 2-way transmitter may keep ﬂ ashing the blue

LED up to 15 minutes after the remote start was initiated or until vehicle is started by

ignition key.

Vehicle has shut down, either by pressing and holding** the button

or completing the run cycle (Transmitter must be in range of the vehicle).

3 Beeps/LED Flashes

Vehicle has started.

Vehicle has received an Initiate Start Command.

Remote Start Status

Transmitter Indicators

1 Beep/LED Flash

2 Beeps/LED Flashes

Steady LED Flash

Vehicle is running.

Safety input triggered:

- Hood opened or gear selector moved while running in remote start

mode.

- Key turned in the ignition on a remote started vehicle.

Transmitter is out of range of the vehicle while trying to remote start or the

vehicle did not receive the command to remote start.

Using the Remote Start Feature, con’t (optional)

* May be activated by a “Press & Hold”, refer to “User Selectable Options” in this manual.

** “Press & Hold” or “Pressing and Holding” refers to pushing the transmitter button for more

than 2.5 seconds.

4280760 Phase 2 VSS_RMST Owners Guide.indd 84280760 Phase 2 VSS_RMST Owners Guide.indd 8 3/22/2017 4:52:31 PM3/22/2017 4:52:31 PM