User's Manual
128-9456
Page 12
© 2015 Voxx Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-9456
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may
cause undesired operation.
Warning!
Changes or modications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unau-
thorized modications to this equipment. Such modications could void the user’s authority to
operate the equipment
To purchase replacement transmitters or to get additional product information go to:
www.prestigecarsecurity.com
Page 12
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Warning!
Changes or modifications not expressly approved by the part responsible for compliance could void the use's authority to operate the equipment
NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
Changes or modifications made to this equipment not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
TO purchase replacement transmitters or to get additional product information go to：
www.prestigecarsecurity.com