User's Manual

128-9446
11 of 12
Page 11
Programming New Or Replacement Transmitters (BANK 1)
Transmitter Model Name Are Found On Back Of The Transmitter
Case. Batteries CR2032 Are Also Indicated There
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Horn Beeps).
3) Press the Lock Button of each transmitter you want programmed until
you hear a chirp from the horn or the parking lights ash.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1
buttons which are typical for most systems.
For additional channel programming beyond the option 1 button, you can
use any unused button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the
following:
From step 3 above:
a) Press and release the valet/programming button 4 additional
times to get to channel 5, then Press any unused transmitter button
or button combination to program.
b) From a, press and release the valet/programming button 1 time to
get to channel 6, then press any unused transmitter button or button
combination to program.
c) From b, press and release the valet/programming button 1 time to get
to channel 7, then press any unused transmitter button or button
combination to program.
Note: Not all systems have channels above 3, check with your installation
center for options your system may or may not have.
Note: Certain systems have the ability to utilize channels 6 & 7 for
driver priority programming. For driver priority, the vehicle must
be equipped with this feature, and the optional feature must
be set up and installed by your installation center. Once this
feature is added when the unlock button of transmitter 1 is used,
it will set driver 1 priority, and when the unlock button of trans-
mitter 2 is used it will set driver 2 priority. In this situation, the
unlock button can be programmed into two receiver channels,
unlock, channel 2 and driver priority 6 or 7. In no other