User's Manual

128-9296
19/24
19
The transmitters are pre-programmed from the factory, If you nd you need to program new or additional
transmitters follow the instructions below.
PROGRAMMING BANK 1 (TRANSMITTERS):
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3) Press the start button of each transmitter you want programmed until you hear a chirp from the horn or
siren or until the lights ash.
4) Turn the ignition switch off. 1 Short followed by 1 Long Chirp indicates exit of programming mode.
The above action programs the start button of the system.
PROGRAMMING BANK 2 (ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1, you will hear
2 chirps, or You can also go right to bank 2 by:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3) Turn the ignition key off then on you will hear 2 chirps.
4 Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use
the lock button of the transmitter to select the feature setting.
Example to set passive arming:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off, then on, Siren chirps 2 times.
4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button
of the transmitter to select two chirps "Passive Arm".
5) To exit the programming mode, turn the ignition key off more than 6 seconds. Siren sounds a short chirp
followed by a long Chirp.
New: The chirp and LED patterns have been changed to make it easier to determine what feature you
are in. As well the feature bank will not time out until the ignition switch is off for more than 5 seconds. The
change will be noted when you get to feature # 11, the LED pattern will be 1 pause, 1,,#12 will be 1 pause,
2, #13 will be 1 pause 3, #22 will be 2 pause 2, etc,. This will make it easier for the technician to determine
what feature they are up to.
Feature Bank Reset: If you wish to reset a feature bank to the default settings,from within that bank, press
and hold the pushbutton on the receiver/antenna for 5 seconds or until a chirp / ash is heard from the
system. This action resets the feature bank. The feature banks are reset individually so resetting bank 2
will not effect bank 3 & visa versa.