User's Manual

128-9296

13/24

Resistive Circuits, Multiplex Circuits As Well As 4 Wire Polarity Reversal and 5 Wire

Alternating 12 Volt Door Lock Control Circuits

These applications require the use of additional components which may include relays, xed resistor, a door

lock interface, or a data module. You can search the vehicle @ www.avxtech1.com, Flash-It.com for vehicle

specic information, or contact our tech service line or web site for additional information.

Additional Harnesses And Connectors For The System

4 Pin Upgrade Telematic Module: (Connector Port)

Red = + 5 Volts / Black = Ground / White = Data TX / Yellow = Data RX

Connect the 4 pin harness found in the Telematic one way or Carlink II kits to the mating port on the con-

trolling circuit.

NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the + 12

volt supply for the two way module must be sourced separately or the unit will not operate.

6 Pin Antenna/Receiver Program Push-Button Switch/LED Connector: Part # 1124293

Plug the previously routed antenna connector from the antenna receiver assemble into the mating connector

of the control module. This connector supplies 5 volts, ground and RF data input and output, LED cathode,

and Valet Enable to and from the antenna receiver and the remote start module. Be certain this connector

is rmly seated making good contact to the control unit.