User's Manual

128-9309

19 of 24

Page 19

To activate this function,

(a) Turn the ignition switch off.

(b) Within 10 seconds of step (a), depress and hold the brake pedal, while press-

ing the key icon transmitter button 2 times.

icon on the display will remain on.

The vehicle will start at the set time 24 hours from when set.

To toggle this feature off, press the option + lock buttons simultaneously until a

beep is heard and the 24 hr timer turns off.

NOTE: The unit will start once and run for the prescribed time. If you require

more frequent starting please refer to auto start up timer mode shown earlier in

this guide.

NOTE: To insure accurate 24 Hour Start up, it is advisable to reset the start time

periodically as time may drift slightly each day.

Timing Count Down

The unit offers an additional count down timer for situations where an alert

tone may be needed to remind you of something important. For instance

you may have a meeting 4 hours from now and you want a reminder in 3

Hrs and 45 Mins. This additional count down timer allows you to set the

count down up 19 Hours and 59 Minutes from the current time and when

the timer reaches zero, the transmitter will emit a tone or vibrate depen-

dent on your preferred setting. See chart for setting the count down time

for this feature.

Valet

When the System is in the valet mode, the icon shown will show in the

display when the status check buttons are activated.

Parking Meter Counter

The transmitter has a built in clock that can count down from 10, 20, 30, 60, 90,

or 120 minutes. This feature is useful when parking the vehicle in a metered

parking lot. If the time on the parking meter is 30 minutes, you can set the count

down timer to 20 minutes. The transmitter will emit a beep tone when the timer

expires to remind you to get back to your vehicle. See following chart for setting

the parking meter count down timer feature.

Alarm Clock Mode

The transmitter has a built in alarm clock that can be set to beep at a cer-

tain time each day. The alarm clock mode must be set, and the feature

turned on. To use this feature please refer to the chart on the following

page.

NOTE: Your system is shipped with two transmitters, 1 two way, shown

on the left and the one way transmitter, shown right. The one and two way

transmitters are programmed from the factory with separate lock & un-