User's Manual

3
The Controller & Transmitter
2-way controller part number: 115-03
1-way transmitter part number: 113-03
Call your dealer or visit
www.caralarm.com to order replacement
transmitters.
“start”/
”unlock”
button
Controller & Transmitter Functions
REMOTE START: Press and release the “START” button
twice. (see installer feature #1 for other options)
THE PARKING LIGHTS WILL FLASH AND THE STA-•
TUS LIGHTS WILL FLASH RAPIDLY.
THE CONTROLLER WILL PLAY THE START MELODY.•
THE IGNITION WILL TURN ON AND THE SYSTEM •
WILL START THE ENGINE.
WHEN THE ENGINE IS RUNNING, THE STATUS •
LIGHTS AND THE PARKING LIGHTS WILL FLASH AS
LONG AS REMOTE START MODE IS ACTIVE.
THE 2-WAY CONTROLLER BUTTON WILL FLASH •
GREEN ONCE EVERY 2 SECONDS.
If the engine stalls, the system will make up to 3 more attempts.•
Each time you park your vehicle, set the climate controls to give you •
the desired interior temperature when you use the remote start.
The engine will run for the preset run time (see user feature #1). •
Run Time Extender• : Press the “START” button one time while in
remote start mode to restart the engine run timer.
NOTE: This can only be used once per remote start cycle. If you decide not to
drive your vehicle, you can turn off the remote start using the same method to turn it
on(keepinmindthattherstpressisconsideredtheRun Time Extender).
Upon entering the vehicle during remote start mode, turn the ignition •
key to the “ON/RUN” position (NOT START!!). When you press the
brake pedal, the remote start will turn off.
Controller battery replacement:
Remove the small screws from the lower
back case, and separate the transmitter
halves. Replace the battery(s) and reas-
semble the transmitter case.
115-03
Battery type:
CR2032 (Qty: 1)
113-03
Battery type:
CR2016 (Qty: 2)