User's Manual

128-9486

Page 6

set up and installed by your installation center. Once this feature is added when the unlock button

of transmitter 1 is used, it will set driver 1 priority and when the unlock button of transmitter 2 is

used it will set driver 2 priority. In this situation, the unlock button can be programmed into two

receiver channels, unlock, channel 2 and driver priority 6 or 7. In no other circumstance will the

system allow a transmitter button to be programmed into 2 receiver channels at the same time.

This remote has the ability to operate 2 similar Alarms From A Single Transmitter. To toggle on

and o󰀨 vehicle one or two,,,

Press the Trunk/Key button + the Lock button for 5 seconds.

The LED ashes 2 times. Release the buttons, to select 2nd vehicle mode.

Program this transmitter into the second vehicle’s system. Any time you are in 2nd vehicle mode

when the transmitter is operated, the LED will ash twice for each function. When in the prime

vehicle mode, the LED will ash once for each function.

To Erase All Transmitters:

1) Turn the ignition switch to the “On” position.

2) Press and release the pushbutton switch found on the windshield mount receiver 3 times.

(The LED on the receiver will ash.

3) Press and hold the push-button switch on the windshield receiver for 6 seconds. The LED

will ash 2X fast which is an indication all transmitters programmed to the system are now

erased.

4) Turn the ignition switch o󰀨.

Once you have erased all transmitters, you will have to go back and program all transmitters

that you want to operate your system.

Transmitter Battery Replacement

5BER17XPR

1) Remove the 00 Phillips head screw from the rear case.

2) Separate the case halves by inserting a small plastic tool in the top right slot.

3) Carefully slide the two CR2025 batteries from the transmitter PCB and dispose of properly.

4) Insert two new CR2025 batteries with the (+) side up away from the PCB.

5) Close the case in reverse of disassembly.

175XPR

1) Locate the slot at the lower right hand side of the transmitter case.

2) Separate the case halves by inserting a small plastic tool in the slot and carefully prying apart

the case halves.

3) Carefully slide the CR2032 battery out from under the battery clip and dispose of properly.

4) Insert a fresh CR2032 battery with the (+) side up away from the PCB.

5) Close the case in reverse order of disassembly.