User's Manual

128-9473

3 of 4

UNLOCKING THE VEHICLE:

If you have an electric door lock, and the Optional Unlock feature was added,

with the vehicle running under command of the remote start unit, press and hold

the transmitter button for 3 seconds until the doors unlock.

CAR FINDER MODE:

Anytime the vehicle is not running under control of the remote start unit, within

operating range of the vehicle, press and hold the push-button of the hand held

transmitter for 4 seconds to activate the car nder mode. The vehicle lights & or

horn will ash - sound for 30 seconds or until the push-button is again pressed

and released.

TELEMATIC UPGRADE:

This system has the ability to have a telematic upgrade module connected to it.

This is an upgrade that can give you control of certain functions of your vehicle

from a telephone, or in some cases a computer interface. Please check with your

installation center for most recent Telematic Upgrades. If you had a Telematic Up-

grade installed, the manual supplied with the upgrade unit will provide an operator's

manual advising of the features of the system and means available to control these

features of your vehicle.

PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)

The Transmitter Model Names 151SP & 1BER15SP are also

Found On Back Of Transmitter Case.

Use Battery CR2032 For 151SP. Use (2) CR 2025's For 1BER15SP

1. Turn the ignition key to the on position.

2. Press and release the valet/programming switch 3 times (Siren Chirps).

3. Press the Transmitter Button of each transmitter you want programmed until you

hear a chirp from the horn or siren or the Parking Lights Flash

4. Turn the ignition switch off.

The above action programs the Start function for this system.

Transmitter Battery Replacement

1) Locate and remove the two "00" point philips head screw on the back of the transmitter

case.

2) Carefully separate the front case from the rear.

3) Slide the battery(s) out from under the battery clip and dispose of properly.

4) Install the new battery(s) with the (+) side facing up away from the circuit board.

5) Close the case and reassemble in reverse of disassembly