User's Manual

37PROPLME Install Guide rev A.
I.T.S. Harness Connections
DK BLUE - Factory Alarm Trigger: Connect this to a wire which triggers the vehicle’s
factory alarm system such as the door ajar, hood or trunk wire.
PURPLE and BROWN - Door Inputs ( + / - ): Connect one of these wires to the vehicle’s
dome light wire.
RED/WHITE - +12 Volt Input: Connect this wire to constant +12 volt source.
BLACK - Ground Input: Connect this wire to chassis ground.
YELLOW - Accessory Input: Connect this wire to +12 volt accessory source.
BLACK/WHITE - Warn Away Horn Output: Connect this wire to the vehicle’s horn wire.
NOTES:
The ITS uses the PURPLE or BROWN (Door Input) to DISARM the optional Warn-Away
feature. The PURPLE or BROWN must sense all of the doors for the ITS to DISARM
properly. It is recommended to only use the Warn-Away feature with vehicle’s that have an
“ALL” door trigger output in the vehicle.
Valet Mode
Valet Mode deactivates both the optional Warn-Away and Factory Alarm Trigger.
To turn Valet Mode ON:
Turn the ignition key to the ON position and press and hold the valet button until the LED
turns on solid.
To turn Valet Mode OFF:
Turn the ignition key to the ON position and press and hold the valet button until the LED
turns off.