User's Manual

Factory Alarm Trigger

The ITS Factory Alarm Trigger is active 30 seconds after the ignition is turned off and

the factory alarm has been set. When a heavy impact is detected the ITS will pulse the

vehicle’s door trigger wire to active the factory alarm.

Optional Warn Away

The optional Warn-Away Trigger is active 30 seconds after the ignition key is turned off

and the dome light shuts off after exiting the vehicle. When a light impact is detected the

system will briey honk the vehicles horn. If at any time a door is opened (dome light “on”),

the Warn-Away Trigger will be bypassed until the ignition key is cycled “ON” and “OFF”.

This feature prevents the Warn-Away chirps of the vehicle’s horn when the customer/user

enters the vehicle. The Warn-Away Trigger will reactivate when the ignition key is cycled

“ON” and “OFF” again.

I.T.S. ACTIVATION

I.T.S. - INTERIOR THEFT SENSOR FUNCTIONALITY

I.T.S. - Interior Theft Sensor Introduction

The system may be used as an I.T.S. (Interior Theft Sensor) and when doing so it is de-

signed to honk the horn if a light impact is detected or trigger the vehicle’s factory security

system if a harder impact is detected.

Note: The vehicle MUST have a factory security system that is triggered by opening the

vehicle’s door.

Option #11 must be changed in the feature programming bank for the system to function

as the I.T.S.. This will also happen automatically when transitioning from Lot mode to Green

mode using an ACM Keypad.

The factory keyless remote can also be used to arm/disarm the I.T.S. sensor as long as

the standard arm & disarm input wires are connected to the vehicle. You may also program

an aftermarket remote transmitter to the unit as well.