User's Manual

1 RED / BLACK 2nd Unlock Output ( - ) 200mA

2 GREEN Unlock Output ( - ) 200mA

3 Red Lock Output ( - ) 200mA

Positive Switching and Positive Switching with 2-step unlock feature:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock

switch.

 Verication: These wires will register positive voltage when the lock and unlock

switches are activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside

the driver’s door.

Verication:This wire will rest at ground and register positive voltage when the

driver’s door is unlocked.

Connect the RED and GREEN or RED/BLACK wires shown in the diagram below.

NOTE: When adding the 2 step unlock feature the RED/BLACK 2nd door unlock wire will

be used to unlock all vehicle doors on the second press of unlock. Two additional

SPDT relays (not supplied) are required. Connect the relays as shown in the

diagram below to unlock the driver’s door on the rst press of unlock.