User's Manual

3 PIN DOOR LOCK HARNESS

1 RED / BLACK 2nd Unlock Output ( - ) 200mA

2 GREEN Unlock Output ( - ) 200mA

3 Red Lock Output ( - ) 200mA

Negative Switching and Negative Switching with 2-step unlock feature:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock

switch.

 Verication: These wires will register ground when the lock and unlock switches are

activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside

the driver’s door.

Verication:This wire will rest at ground and register positive voltage when the

driver’s door is unlocked.

Connect the RED and GREEN or RED/BLACK wires shown in the diagram below.

NOTE: When adding the 2 step unlock feature the RED/BLACK 2nd door unlock wire

will be used to unlock all vehicle doors on the second press of unlock. An additional

SPDT relay (not supplied) is required. Connect the relay as shown in the diagram

below to unlock the driver’s door on the rst press of unlock.