User's Manual

3 PURPLE Door Trigger Input ( + )

Locate the vehicle’s dome light or door pin switch wire.

Verication:Thiswirewillregisterpositivevoltage(POS)whenthedoorisopened

and the interior light is on. This wire will register ground or “0” Volts when the door is

closed and the interior light is off.

Connect the PURPLE wire to the vehicle’s positive door input wire(s).

NOTE: Certain vehicles may require multiple connections. Refer to vehicle application

guide

4 RED Parking Light Polarity

5 WHITE Parking Light Output ( + / - )

Locate the vehicle’s parking light wire at the vehicle light switch.

 Verication:This wire will register positive voltage or ground when the vehicle parking

light switch is turned to the ON position.

These wires are the COMMON and NORMALLY OPEN contacts of the on-board parking

light relay. If the vehicle’s parking lights are a +12 volt switched system, connect

the RED wire to a fused +12 volt battery source, and connect the WHITE wire to the

vehicle’s parking light wire. If the vehicle’s parking lights are a chassis ground switched

system, connect the RED wire to a chassis ground source, and connect the WHITE wire

to the vehicle’s parking light wire.

6 BROWN Door Trigger Input ( - )

Locate the vehicle’s dome light or door pin switch wire.

Verication:Thiswirewillregisterground(NEG)whenthedoorisopenedandthe

interior light is on. This wire will register positive voltage when the door is closed and

the interior light is off.

Connect the BROWN wire to the vehicle’s negative door input wire(s).

NOTE: Certain vehicles may require multiple connections. Refer to vehicle application

guide