User's Manual

17PROPLME Install Guide rev A.
ON BOARD SHOCK SENSOR
Adjusting and Testing the Shock Sensor
It is recommended that you test the shock sensor after making any adjustments to the
sensitivity.
The shock sensor has two levels of protection, one to detect light impacts to the vehicle
and one to detect larger impacts. Adjusting the shock sensor’s sensitivity dial will adjust
both light and full triggers zones simultaneously. If the light impact zone, also referred to
as warn-away, can be turned completely off in option programming.
To test the shock sensor, arm the system and wait 6 - 10 seconds for the zone to stabi-
lize, then rmly strike the vehicle being careful not to damage it. Repeat if necessary.
• Increase sensitivity by turning the adjustment dial clockwise.
• Decrease sensitivity by turning the adjustment dial counter clockwise.
When using the aftermarket remote transmitter the shock sensor can be temporarily
bypassed when for one arm cycle by pressing Trunk or Find button within 5 seconds of
pressing the Lock button.