User's Manual

128-9299

4 of 4

To purchase replacement transmitters

or to get additional product information go to:

www.prestigecarsecurity.com

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry

Canada.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that

may cause undesired operation.

Warning!

Changes or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modications to this equipment. Such modications could void the user’s authority to operate

the equipment

Transmitter Battery Replacement

1) Locate and remove the "00" point Phillips head screw on the back of the transmitter

case.

2) Carefully separate the front case from the rear.

3) Slide the CR2032 battery out from under the battery clip and dispose of properly.

4) Install the new battery with the (+) side facing up away from the circuit board.

5) Close the case and reassemble in reverse of disassembly

FUNCTION SETTING CHART

To be completed by installer

Run Time 5 Min  10 Min  15 Min  20 Min  45 Min 60 Min

While Running Unlock Yes  No 

Lights Pulse  Steady 