User's Manual

128-9299
3 of 4
3
UNLOCKING THE VEHICLE:
If you have electric door lock, and the Optional Unlock feature was added, with
the vehicle running under command of the remote start unit, press and hold the
transmitter button for 3 seconds until the doors unlock.
CAR FINDER MODE:
Anytime the vehicle is not running under control of the remote start unit, within
operating range of the vehicle, press and hold the push-button of the hand held
transmitter for 4 seconds to activate the car nder mode. The vehicle lights will
ash for 30 seconds or until the push-button is again pressed and released.
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it.
This is an upgrade that can give you control of certain functions of your vehicle
from a telephone, or in some cases a computer interface. Please check with your
installation center for most recent Telematic Upgrades. If you had a Telematic
Upgrade installed, the manual supplied with the upgrade unit will provide an
operator's manual advising of the features of the system and means available to
control these features of your vehicle.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
Transmitter Model Name, 141BP Is Also Found On Back Of
Transmitter Case. Use Battery CR2032
The following steps are used to programs the Start button for the one button start
systems.
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Button of each transmitter you want programmed until you hear
a chirp from the horn or siren.
4) Turn the ignition switch Off.
Note: Some systems will not have a audible sound associated with programming,,,for these
systems the lights will ash.