User's Manual

128-8809
6 of 8
6
Remove the three #0 point phillips
screws shown then carefully separate
the case halves with the edge of a
finger nail or a small common screw-
driver. Keep hold of the metal case
with the key ring loop as this is a
separate component.
Carefully remove the discharged
battery by sliding it out from under the
clip in the direction indicated by the
arrow in the diagram. Properly dispose
of the discharged battery and insert a
new CR2032 taking care to arrange it
so that the + is facing up toward the +
symbol on the battery clip. Reassemble
in the reverse of above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE:The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment