User's Manual

Using Your Remote Vehicle Starter, continued
To begin the 2 / 4 hour start up timer mode from the remote control:
1. Activate the remote vehicle start feature using the remote control.
2. Shutdown the remote vehicle starter using the remote control (press the KEY
button 2 times).
3. Within 10 seconds press KEY button on the remote control 4 times.
The parking lights will flash and the system will sound 4 times indicating the 2 / 4 hour start
up timer mode has been activated. The vehicle will start every 2 or 4 hours and run for the preset
time limit (5, 10, 15 or 20 minutes) and then shutdown. This will continue for 48 hours unless the
2 / 4 hour start up timer is cancelled.
To cancel the 2 /4 hour start up timer mode:
1. Start the vehicle using the ignition key, then press the brake pedal.
Or
2. Activate the remote vehicle start feature using the remote control.
Operating the Temperature Start Mode
The system has the ability to start the vehicle when the temperature reaches 0 degrees. To toggle this
feature on/off using the remote control press the UNLOCK and KEY buttons simultaneously for 1
second.
Note: This feature must be turned ON in options programming. Check with your installing dealer to
insure this feature is set to the ON position.
Operating the Daily Start Timer
The system has the ability to start your vehicle based on a 24-hour countdown timer. To activate this
feature, using the remote control press the LOCK and KEY buttons simultaneously for 1 second.
The system will begin counting sown from 24 hours, and start the vehicle when it reaches zero. This
timer will only activate 1 time and will need to be reactivated for each 24 hour period.
Remote Start Safety Features
For safety and security reasons, the system will shutdown or prevent the remote vehicle starter from
activating if any of the following occur:
1. The vehicle hood is open.
2. The brake pedal is pressed prior to turning the ignition key to the ON position.
3. The engine reaches 3 times its normal idle speed.
4. The safety (red handled) control switch is turned to the OFF position.

This device complies with part 15 of the FCC rules. Operation is subject to the following two 
conditions.
1)•This device may not cause harmful interference, and
2)•This device must accept any interference received, including interference that may cause 
undesired operation.

Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by 
the part responsible for compliance could void the user’s authority to operate the equipment.
