User's Manual

Using Your Remote Control, continued
Two Stage Door Unlock
If this feature is enabled on your system, pressing the UNLOCK icon button one time on the remote
control will unlock only the driver’s door. Press the UNLOCK icon button again to unlock the
remaining doors.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the TRUNK icon button on the remote
control for 2 seconds will open the vehicle’s trunk or hatch.
Using the Progressive Car Finder Feature
Press the LOCK and UNLOCK buttons together on the remote control to locate your vehicle. The
system will sound 5 times at low volume increasing in volume each of 3 times the button is pressed.
Using the Personal Protection Alarm (Panic)
Press and hold the LOCK and UNLOCK buttons together on the remote control for 2 seconds to
activate the personal protection alarm. The system will sound for 30 seconds. Pressing any button
on the remote control will turn the personal protection alarm off.
Using Your Remote Vehicle Starter
Remote Starting Your Vehicle
To activate the remote vehicle start function, press and release the KEY button on the remote control
two (2) times within 2 seconds. The system will sound, the parking lights will flash 1 time and the
system will check the vehicle to ensure it is safe to start, if all safety parameters are correct, the
vehicle will start within 5 seconds (diesel vehicles will take longer). The vehicle’s parking lights will
turn on (or flash depending on system settings) as a visual indication that the vehicle has started and
is running.
If your vehicle stalls or does not start, the system will pause 5 seconds, then try 3 more times to start
the vehicle (a total of four attempts). The system will pause 5 seconds between each start attempt. If
the vehicle does not start after the fourth attempt, the system will abort the remote vehicle start
process.
Entering the Vehicle While it is Running via Remote Vehicle Start
1. Unlock the vehicle’s doors.
2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3. Insert the key into the ignition switch and turn to the ON or RUN position.
4. Press the brake pedal. The remote vehicle starter will disengage and the vehicle will operate
normally.
Using the Safety (Red Handled) Control Switch
The safety (red handled) control switch allows you to temporarily disable the remote vehicle starter
feature, this is especially helpful when having your vehicle serviced or valet parked. To disable the
remote start, move the safety (red handled) control switch to the OFF position.
Preheating or Precooling the Vehicle’s interior
Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the
system starts the vehicle, the heater or air conditioning will activate and heat or cool the vehicle’s
interior to your setting.