User's Manual

128-6987
1 of 5
1
2
1
3
3
4
5
BUTTON
RECEIVER
CHANNEL
SYSTEM FUNCTION
Lock and Arm Alarm, also initiates and
terminates *Panic
Unlock and Disarm, also initiates and
terminates *Panic. Programmable to
unlock drivers door and or all doors.
Lock and arm/unlock and disarm. May
be programmed to unlock driver's door
or all doors. Also will initiate and
terminate *Panic.
Pulsed output to OUTPUT CHANNEL 2
/ TRUNK RELEASE.
When pressed and release two times,
will provide pulsed output to OUTPUT
CHANNEL 3
When so equipped, this button can be
used to operate an optional device
connected to OUTPUT CHANNEL 4.
When so equipped, this button can be
used to operate an optional device
connected to OUTPUT CHANNEL 5.
These transmitters make use of icons (symbols) to identify the reaction
your security system/keyless entry/and or remote start system, where
applicable, will have when any icon (button) is pressed. These
iconsare programmed at time of installation to meet the needs of the
individual and to complement the vehicle that the system is installed in.
To replace a transmitter or add transmitters, please follow the
programming instructions listed on the pages of this manual.
Transmitter Programming Guide
Model5WTXB
* Where So Equipped
128-6987
2 of 5
2
Some of the more popular options available for the unused Option
Buttons of your transmitter are:
AS 9554 Remote Garage Door Interface
AS 9075 Remote Car Starter Module
AS 9153 Remote Window Roll Up Module
AS 9256 Remote Trunk Release Relay
Although the most common use of the transmitter buttons are shown
on the front page of this guide, any button or button combination can be
programmed into any receiver channel. Additionally, if all 4 buttons are
used and you require access to a 5th channel, you would program a
combination of buttons to control the 5th function. i.e... You have
programmed lock for arm, unlock for disarm, trunk for trunk release,
and Opt1 for garage door operation, and you've added a window up
module that you want independentcontrol of, you would program un-
lock and trunk buttons pressed simultaneously into the receiver to con-
trol this function independently. Also, if you do not program a transmit-
ter button into channel 2 which is the separate unlock/disarm chan-
nel, then whatever button is programmed into channel 1 will serve
as both lock/arm & unlock/disarm.
PROGRAMMING TRANSMITTERS:
NOTE: It is important to remember that during the programming mode,
each individual step must be completed within 15 seconds of
the previous step. If the 15 second time limit expires between
steps,the unit will automatically exit the program mode. This
is indicated by a long chirp from the siren.
Non alarm models will flash the parking lights only to confirm the
transmitter code has been learned and stored.
NOTE: Because the system may be capable of sounding a siren, the
vehicle horn, or both, where the siren chirp is referenced be-
low, the siren may chirp, the horn may beep, or both devices
may sound.
TO PROGRAM ADDITIONAL TRANSMITTERS:
1)Enter the vehicle, and turn the ignition switch to the ON position.
2)Press and release the valet push button switch three times.
3)The dash mounted LED will flash 1x, and the siren will chirp 1x,
indicating that the system is ready to accept programming of channel
#1 which is arm/lock, disarm/unlock/unlock 2, and panic functions.
4)Press and hold the lock or lock/unlock symbol button of the transmit-
ter you wish to program for 4 seconds or until a long chirp is heard
from the siren. Repeat step 4 for each transmitter you wish to
program.
NOTE: If your transmitter button has the Lock/Unlock icon on one
button, press and release the valet push button switch 2 times
then move on to step #8.