Model; APTNESS The i excluded with the system have been pre programmed al the factory, with each bullion pre assigned Io control a specific function of he system. Although the system in the vehicle has either channel RECEIVER, depending on the model, he banisters included with the system dre 7 channel transmitters.
PROGRAMMING TRANSMITTERS: iris important lo remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous tiles. When the 15 second time limit Is allowed to expire, the system will automatically exit program mode. This is indicated by a long “chirp” from the siren. Additionally, any ime the ignition key is tamed off while programming, the system will immediately exit program mode. This is also indicated by 2 long “chirp” from the siren.
Up to 4 transmitters can be programmed, press and hold the selected bunion of each additional transmitter until the chirp tone is heard, or move to step Press and release the valetudinarian switch ong time 1b advance to channel 2. (8) Disregard this step. (b} The dash mounted LED. will flash 2 times, and the siren will “chirp” 2 times indicating that the system is ready to accept programming for channel 2. Unlock Unlock, Disarm, and Panic.
{b} Press and hold any combination of two bunions simultaneously, until the siren emits a long chip tone. This confirms that programming of channel 4 was successful. Up 10 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp lone is heard, or press and release the push button switch to taxi the programming mode, or tun the ignition switch off to exit the programming mode.
BATTERY REPLACEMENT: The transmitter Incorporates @ small red LED, built into the case, This Led. can be used tb indicate battery condition: You will tic a decrease in transmitter range ‘as the battery condition’ deteriorates. To replace the 1. Revive the transmitter cover by removing the small screw from the back of the transmitter case. 2. Remove the discharged battery, making note of the orientation of the + and contacts, and dispose of properly.
ORDER FORM FOR APSS9YBTI TRANSMITTER Sa CHS IMPORTANT: To help us expedite your order, please print all of the information legibly, and mail this form and your payment according lo the instructions below. Please indicate which button pad is used with your transmitter as indicated above. 1.Name : Address City: State: Zip Code: 2. Telephone Number :( 3 3. Enter the total number of transmitters required here 4. The cost per transmitter is § 85.00. §.
FCC ID EI VA TIC This device complies with FCC Rules Part 15 Operation is subject to the following two conditions (1) This device may not cause harmful interference and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible “for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
