User's Manual

9
Installer Programmable Features (cont’d)
Feature #4 Satellite Relay Port Green Wire Function
Starter (press the brake pedal 1 time to program) - DEFAULT
Pulse After Engine Start (press the brake pedal 2 times to program)
Status Output (press the brake pedal 3 times to program)
Domelight (press the brake pedal 4 times to program)
This feature changes the operation of the Green wire (negative) on the satellite relay
port.Thisgivesyoutheexibilitytoaccomodatecertainvehiclesthatrequireany
out-of-the-ordinary pulses or remote start timing.
Starter setting operates as a secondary START output. This will have the same
pulse timing as the large Violet wire on the main harness.
Pulse After Start setting will give a 0.8 second pulse immediately after the engine
starts and is running.
Status Output setting will behave like the ignition output except it turns on 1.5
seconds earlier than the primary ignition output..
Domelight provides domelight supervision output. It will turn on when the system is
unlocked and after turning the ignition “off”.
Feature #5 Extended Starter Cranking Time
0.7 Second (press the brake pedal 1 time to program) - DEFAULT
1.00 Second (press the brake pedal 2 times to program)
1.5 Seconds (press the brake pedal 3 times to program)
2.25 Seconds (press the brake pedal 4 times to program)
This feature determines the crank time of the 1st start attempt when in “Tachless”
mode.Iftheenginedoesn’tstartontherstattempt,itwillretryupto3moretimes
extending the crank time by an additional 0.2 second with each attempt..
Feature #7 Unlock Output Functions
0.8 Second Output (press the brake pedal 1 time to program) - DEFAULT
3 Second Output (press the brake pedal 2 times to program)
Double 0.8 Sec Unlock (press the brake pedal 3 times to program)
This single feature gives the installer several needed options, to match the system’s
doorlocking outputs to suit different vehicle requirements.
0.8 Second Outputs on the unlock output.
3 Second Outputs on the unlock output.
Double 0.8 Sec Unlock Output
Feature #6 Low Temp Crank Extender
0ms (Off) (press the brake pedal 1 time to program)
200ms (press the brake pedal 2 times to program) - DEFAULT
300ms (press the brake pedal 3 times to program)
400ms (press the brake pedal 4 times to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra
crank time to the base timing (see installer feature #5). It applies to tachless modes
only (installer feature #2)