User's Manual

Step 1 Turn the ignition key “ON”, then “OFF”

Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user

features (10 times to access installer features).

~ The parking lights and the status light will turn on.

Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-

responding with the desired feature’s number.

 ~Thestatuslightsandtheparkinglightswillashequaltotheselectedfeature.

Step 4 Change the feature by pressing the brake pedal the same number of times

that corresponds with the desired setting.

 ~Thestatuslightsandtheparkinglightswillashequaltotheselectedsetting.

Step 5 If you wish to change more features, repeat steps 3 & 4 at this time.

Step 6 To exit programming, turn the ignition key “ON” then “OFF”. Or, you can wait

10 seconds for programming mode to expire. The lights will turn off.

Programming Features

Feature #1 Remote Start Run Time

10 Minutes (press the brake pedal 1 time to program) - DEFAULT

5 Minutes (press the brake pedal 2 times to program)

15 Minutes (press the brake pedal 3 times to program)

20 Minutes (press the brake pedal 4 times to program)

This feature sets the period of time that the engine will run after being remotely

started. If the engine is not stopped by controller/transmitter command or a safety

circuit violation, the engine will automatically stop upon the expiration of the selected

time period. Caution: The remote engine starting feature should NEVER be

used when the vehicle is parked in an enclosed structure or garage.

ThisgroupofUserProgrammableFeaturesareallaccessedasagroupintherst

level of features’ programming. These features have a direct affect upon the sys-

tem’s operations, so the programming and operation of each are described.

Feature #2 Steady/Flashing Lights During Remote Start

Steady (press the brake pedal 1 time to program) - DEFAULT

Flashing (press the brake pedal 2 times to program)

ThisFeaturecongurestheoperationofthevehicle’sparkinglightsduringthe

remote start operation. The default setting turns on the parking lights during remote

start;theothersettingashestheparkinglightsonandoffduringremotestart.

User Programmable Features