User's Manual
3
The Transmitter
Transmitter part number: 113-03
Call your dealer or visit
www.caralarm.com to order re-
placement transmitters.
Transmitter battery
replacement:
Remove the small screw from the
lower back case, and separate the
transmitter halves. Replace the 2
CR2016 batteries and reassemble
the transmitter case.
“start”/”unlock”
button
Transmitter Functions
REMOTE START: Press and release the “START” button
twice. (see installer feature #1 for other options)
THE PARKING LIGHTS WILL FLASH AND •
THE STATUS LIGHTS WILL FLASH RAPIDLY.
THE IGNITION WILL TURN ON AND THE •
SYSTEM WILL START THE ENGINE.
WHEN THE ENGINE IS RUNNING, THE •
STATUS LIGHTS WILL FLASH SLOW AND THE
PARKING LIGHTS WILL STAY ON AS LONG AS
REMOTE START MODE IS ACTIVE.
If the engine stalls, the system will make up to 3 more attempts.•
Each time you park your vehicle, set the climate controls to give you •
the desired interior temperature when you use the remote start.
The engine will run for the preset run time (see user feature #1). •
Run Time Extender• : Press the “START” button one time while in
remote start mode to restart the engine run timer.
NOTE: This can only be used once per remote start cycle. If you de-
cide not to drive your vehicle, you can turn off the remote start using the
samemethodtoturniton(keepinmindthattherstpressisconsidered
the Run Time Extender).
Upon entering the vehicle during remote start mode, turn the ignition •
key to the “ON/RUN” position (NOT START!!). When you press the
brake pedal, the remote start will turn off.