11 Product Diagram Ear Buds Charging Case o Rear Mic Tap Ara LED Front Mic #Pisa chocs and replace Ear Tip [o slut your preference. ob E Remove insulating Sheet Remove Insulating sheet from back side of earbuds. Insisting Sheet a E Battery Charge Insert USB type A connector of USE Charge Cable to USB AC charger or USB port of PC, and insert Type C USB connector to USE port of Charging Case. Put the Ear Buds into Charging case. While charging, the LED light constantly.
[SEED B Pairing Be Charge Case Battery To use Ear Buds first time, you must pairing Ear Bud with mobile phone or player. Insert USB type A connector of USB Charge Cable to Once your Ear Buds is paired with other devices, they will remain paired and USB AC charger or USB port of PC, and insert Micro automatically recognize each other. USB connector to USB port of Charging Case. Depending of battery level , the number of lit LED [Firer time to use] will change.
18 Ambient Mode This device is equipped with an Ambient mode that allows you to listen to ambient sounds from the microphone. When the wind hits the earphones with the Ambient mode enabled, a wind noise can be heard. Thesis not a product defect.
17 Frequent Asked Questions Suddenness | heard io sound from one earbud. Please tum off earbud and tern on it again. Q) The white LED lamp of the earphone is continuous blinking. A} With the earphones on the side that is not blinking continuously white, put the earphones in the charging case, press and hold for about 18 secants, then double tap and remove It from case. When the continuous white flashing of both earbuds stops, try pairing them with phone again. q} Bluetooth connection has dropped.
