Operation Manual

2625
EN
EN
Detach canopy and
seat pad
1 Detach the snaps to disassemble the canopy, press the
button in the canopy mount and pull the canopy bow out.
(33)
2 Pull the fastening pieces underneath the edge of the seat
out. (34)
3 Press the red button to disengage the buckle
(23).
Remove the Infant Insert and crotch strap.
4 Detach the elastic band on the head support, and then
remove the head support.
5 Remove the seat pad from the adjustment button as shown
in.
(35)
6 Remove the seat pad from the Stroller release button as
shown in. (36)
Installation
without base
1 DO NOT install this infant child restraint on vehicle seats with
Lap Belts. (37)
2 This infant child restraint is suitable for vehicle seats with a
3-point Retractor Safety Belt (without base) only. (38)
3 Place the infant child restraint onto the vehicle seat where
you wish to put it. Pull the vehicle safety belt out and lock
it into the vehicle buckle, sliding the vehicle lap belt into the
side guides of the infant child restraint. (39)
The infant child restraint can not be used if the vehicle
safety belt buckle (female buckle end) is too long to
anchor the infant child restraint securely. (39)
4 Slide diagonal belt into the rear guide. (40)
5 Pull the vehicle shoulder belt to fasten the infant child
restraint tightly and securely. (41)
6 Level line on carrier must be level to the ground when the
infant child restraint is installed. (43)
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the infant child restraint, always check
that the vehicle belts are routed correctly and securely
fastened into the vehicle buckle. (42)