Operation Manual

2221
EN
EN
The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing down on
the front of the base.
Squeeze the load leg releasing button, then shorten the
load leg upwards.
The completely assembled base is shown as
(12)
The ISOFIX connectors must be attached and locked
onto the ISOFIX anchor points. (12) -1
The load leg must be installed correctly with green
indicator. (12) -2
6 To remove the base, pull the base backwards while pressing
the buttons on the ISOFIX connectors. (13)
7 Press the ISOFIX releasing button to fold the ISOFIX.
(14)
8 Push the infant child restraint down into the base (15), if
the infant child restraint is secure, the infant child restraint
indicator shows green. (16)
Pull up on the infant child restraint to be sure it is
securely latched into the base.
9 Level line on carrier must be level to the ground when the
infant child restraint is installed.
(43)
10 To release the infant child restraint, pull the infant child
restraint up while squeezing the infant child restraint release
button. (17)
Height Adjustment
for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper
height. Please choose the proper pair of shoulder harness slots
according to the child’s height.
Shoulder Harness Straps must go into the harness slots
nearest to your childs shoulders (18), but not above the
shoulder line. (19)
If the Shoulder Harness Straps are not at proper height, the
child might be ejected the infant child restraint if there is a
crash.
Squeeze the head support adjustment lever
(20), meanwhile
pull up or push down the head support until it snaps into one of
the 7 positions. The head support positions are shown as (21).