Operation Manual

2019

Contents

of the box

Infant Child Restraint

Cold Weather Boot

Tools Needed: None

Handle

adjustment

1 The handle of the infant child restraint can be adjusted to 3

positions.

Rocking position. (5) -1

Baby chair position. (5) -2

Position for car, hand or stroller transportation. (5) -3

2 To adjust the handle positon, squeeze handle buttons on

both sides to release it. (6) -1

3 Rotate handle until it clicks into any of the 3 positions. (6) -2

Installation

with base

1 Unfold the load leg from storage compartment. (7)

2 Fit the ISOFIX guides with the ISOFIX anchor points. (8)

The ISOFIX guides can protect the surface of the vehicle

seat from being torn. They can also guide the ISOFIX

connectors.

3 Rotate the ISOFIX connectors 180 degrees until they are

pointing in the direction of the ISOFIX guides.

(9)

4 Line up the ISOFIX connectors with the ISOFIX guides, and

then click both ISOFIX connectors into the ISOFIX anchor

points. (10)

Make sure that both ISOFIX connectors are securely

attached to their ISOFIX anchor points. There should

be two audible clicks and the colors of the indicators

on the both ISOFIX connectors should be completely

green. (10) -1

Check to make sure the base is securely installed by

pulling on the both ISOFIX connectors.

5 After placing the base on the vehicle seat, extend the load

leg to floor

(11). When the load leg indicator shows green

means it is installed correctly, red means it is installed

incorrectly. (11)