User's Manual

9 | Page
Proprietary and Confidential Revised 10-11-11
The Subsequent Message function is configured using the Subsequent dialog entry boxes:
Subsequent Messages are sent following the Standard report. The “Subsequent Messages” dialog
configures the count of messages to be sent subsequent to the standard report. The “Subsequent
Message Interval” sets the time in hours and minutes between subsequent reports.
For example, a device configured to report daily at 8 AM and hourly thereafter for 6 hours would be
configured as:
Note: When programming
SXL1
for Time of Day reporting:
Programming for Time of Day mode within 1 hour of the scheduled time will result in the first days
message being pushed out 24 hours. Also, if the device time is not current, the first time of day event may
take a complete 24 hours from time of program to complete. Users should thus allow up to 48 hours for
the unit to begin reporting on schedule.
Time of day reporting mode is set in UTC. Displayed below the UTC setting is the correlating time of your
current time zone as set by your computer.