User's Manual

8 | Page
Proprietary and Confidential Revised 10-11-11
Standard Reporting Tab
The “Standard Reporting” tab is used to configure the device for routine position reporting. The SXL1
can be configured to report on a time delay between reports (Standard Interval) or at a specific time
of day (Time of Day). The pull down dialog box is used to select one or the other mode.
Or
Note that if Standard Interval is selected, the user may use the “Days, Hours, Minutes” controls to set
the amount of time between a standard location report. If “Time of Day” is selected, the “Days”
control is not available, the user is prompted to select the hour and minute of the day for reporting.
The device will wake once a day at this time to perform the standard report. Time of Day is provided
in UTC (GMT) format only. Displayed below the UTC setting is the correlating time of your current
time zone as set by your computer. If enabled for Time of Day, the user should specify the time at
Greenwich Mean Time for operation.