User's Manual

7 | Page
Proprietary and Confidential Revised 10-11-11
SXL Tab
The “SXL” tab only appears if the program detects that a SXL1 programmer is attached
to the computer. The SXL tab contains functions specific to the RF link between the
transceiver in the SXL1 and the SXL1 programmer.
When the program is first opened and it detects a SXL1 programmer, it will initiate a
scan for SXL1 devices within its RF range. The scan will last approximately 7.5 seconds.
If the ESN of the desired SXL1 does not show up in the discovered SXLs dialog box
there are 2 ways to try acquire a RF link with it. The first is to click the “Rescan” button.
This will start another 7.5 second scan for available devices. If the ESN is known it may
be typed into the lower dialog box and the “Add ESN(s)” button is clicked. This causes
the programmer to try and talk specifically to the specified device. Once the device is
found it will show up in the dialog box with the Status of connected listed next to it.
Click on the ESN that you would like to configure.
If the desired profile is currently being displayed by the setup tool and there are more
than one SXL1 that needs to be configured with this profile, click and drag down,
highlighting all of the devices to be configured. Once the devices are high lit, click the
“Program” button to configure them all at the same time.