User's Manual

11 | Page
Proprietary and Confidential Revised 10-11-11
In Motion: In Motion mode configures the device to detect start and stop of motion and report at a
set interval while remaining in motion. The Sensitivity and Start and Stop Time configurations are as
described earlier. The Subsequent Message Interval controls set the time between reports while the
unit remains in motion. The Subsequent Message dialog (count) is ignored.
Triggered Reporting Tab
The “Triggered Reporting” tab is used to configure the device for alarm detection and reporting. The
SXL1 has two integral alarms that may be configured, magnet reed switch.
The magnet reed switch detects the presence or removal of the magnet inserted in the top of the
SXL1 enclosure. Removal of the magnet while the device is asleep will initiate operation of the
device. Action on reinsertion/removal of the magnet is configurable. Three modes of operation are
supported for magnet function while the device is in run mode.
Disable: Disable magnet mode configures the device to ignore any magnet reinsertions or removals
while in run mode.
Resume Sleep: Resume Sleep magnet mode configures the device to return to low-power sleep
state when the magnet is inserted for 15 seconds. This mode configures the device to use the
magnet as an on/off switch. Off when the magnet is inserted and on when it is removed.