User's Manual

10 | Page
Proprietary and Confidential Revised 10-11-11
Also, on the Standard Interval tab is the dialog to configure the Engineering Message. The
Engineering Message is a transmitted message containing data related to the health and operation of
the SXL1. It is advisable to send the Engineering Message routinely, typically monthly or bi-weekly.
The Engineering message interval may also be configured for time of day operation. This is useful,
for example, when requiring a daily count of engine runtime.
Motion Reporting Tab
The “Motion Reporting” tab is used to configure the device for detecting and reporting while in motion.
The Motion Reporting Mode pull down dialog box is used to select one of four modes of motion
detection and operation:
Disabled: Disabled mode configures the device to do nothing regarding motion. The Sensitivity and
Stop Time dialogs are ignored.
Start Only: Start Only mode configures the device to detect start of motion and report. The
Sensitivity sets the device for low, medium and high sensitivity. Stop Time sets the amount of time in
minutes that the unit does not detect motion, before the device drops out of motion. The Start Time
sets the amount of time in minutes that the unit detects motion, before the device reports in motion.
As with the Standard reporting function, the device may be configured to report subsequently
following motion start detection. For example, a device may be configured to detect motion start and
report every 30 minutes subsequently for 4 reports.
Start / Stop: Start / Stop mode configures the device to detect start or stop of motion and report.
The Sensitivity and Start and Stop Time configurations are as described earlier. The device only
reports start and stop of motion. No subsequent reporting is configurable in this motion mode.