User's Manual

Location 10, events to report to e-mail
Phone line is good. This location has 16 segments.
Note:
Reporting must be enabled in the control panel for this location to function.
This location selects the partitions to include when reporting to e-mail. To exclude any partition from
reporting, turn off the LED corresponding to that particular partition number. Enter the numbers of the
partitions to include for each type of report found in segments 1 through 16. Factory default is all partitions
off. for all segments.
Table 15 describes the segment options.
Location 11, special events to report to e-mail
Phone line is good. This location has 8 segments.
This location selects the partitions to include when reporting special events to e-m
ail. To exclude any partition
from reporting, turn off the LED corresponding to that particular partition number. Enter the numbers of the
partitions to include for each type of report found in segments 1 through 4. Factory default is all partitions off
for all segments. Segments 5 to 8 are reserved for future use.
Table 16 describes the segment options.
Table 15. Location 10 options
Segment Description
1 Alarms
2 Open/close
3 Bypass
4 Zone trouble
5 Power trouble (AC failure or low battery)
6 Siren and telephone fault
7 Test reports
8 Program, download, and log full
Segment Description
9 Tampers
10 Short circuit and ground fault
11 Sensor lost
12 Sensor low battery
13 Expander trouble
14 Failure to communicate
15 Zone activity monitor
16 Reserved for future use.
Table 16. Location 11 options
Segment Description
1 Alarm restores
2 Telephone fault
Segment Description
3 Start download
4 Fail to communicate, data lost