User's Manual

Location 0, programming the mode
This location has five numeric data segments. This location contains the system identification numb
er (SID).
Factory default is 0-0-0-0-0 for AutoSID.
Note:
If manually entering an SID, use leading zeroes.
Location 1, feature selection
This location has four segments. Segment 1 contains the options to be programmed for the functioning of this
module. Factory default for all Segment 1 options is off. Table 5 describes the options
Table 5. Segment 1 options
Segment 2 programs host acknowledge
ment requirements. Factory default for all Segment 2 options is off.
Table 6 describes the options.
Table 6. Segment 2 options
1 Daily test will be performed 24 hours (± 10 minutes) from time this option is programmed.
2 Weekly test will be performed 168 hours (± 10 minutes) from time this option is programmed.
3 Some older SIA DCS compatible receivers may not support the use of area (partition) modifiers. In such cases, the area
modifier must be disabled (Option 8 on).
Segments 3 and 4 are reserved for future use.
Option Description On Off
1 Format SIA Contact ID
2 Test signal Daily 1 Weekly 2
3 System preference Use A or B side only No preference
4 B side preference B side (if option 3 is on) A side
5 Alternate MIN Disabled Enabled
6 Disable cellular service LEDs Disabled Enabled
7 Enable tamper switch Enabled Disabled
8 Disable SIA DCS area modifier 3 Disabled Enabled
Options Description On Off
1 Central station messages Enabled Disabled
2 E-mail messages Enabled Disabled
3 Pager messages Enabled Disabled
4 Periodic test signals Enabled Disabled
5 to 8 Reserved for future use.