User Manual

4
I NSTALLATION S TEPS
1. For new customers, establish an account with Uplink by visiting the
www.uplink.com website and requesting a new account.
2. The AnyNET Module must be activated and configured from the Uplink website
at www.uplink.com or by calling Uplink Support at 1-888-987-5465.
3. Install the Module’s antenna on top of the unit.
4. Before permanently installing the unit, test signal strength of the unit by connect-
ing a 12 VDC, 2 A capable power supply.
5. Upon initial power up, observe the status LEDs located on the Module's front
panel to determine unit and network status:
6. After successfully testing the unit, disconnect all power before installation.
7. Mount or place the unit in an area that is dry and free from metal objects,
obstructions, and it is recommended that it is above grade level.
8. Wire unit per the Unit Wiring section on page 6.
Table 1: LED indications
NETWORK
ON GSM and GPRS networks available
Slow Blink Only one network available
Fast Blink No network available
NOTE
If after waiting for at least three minutes the unit continues with
a fast blink call Uplink customer support at 1-888-987-5465 to
check network availability in your area.
SERVICE
OFF No GSM service
Slow Blink Service and signal less than -111 dBm (not recommended)
Fast Blink Service and signal between -109 dBm and -53 dBm (good)
ON Service and signal greater than -51 dBm (best)
COMMS
Intermittent Blink Active (internal device communications only)