User's Manual

5
9. The AnyNET Module is configured via the DIP switches on the front panel.
Figure 1: Detail of Dip Switch
Set DIP switches according to the following table:
10. After attaching power, wait at least 2 minutes and then perform a central station
test to verify correct operation.
Figure 2: AnyNET Module
Switch# Settings
S1 reserved (set to off)
S2 reserved (set to off)
S3 and S4 S3 S4 Input 1 Type
OFF OFF Standard Input
OFF ON Pulse Counter
ON OFF Timed Bell
ON ON Sampled Siren
S5 OFF Output Normal 1 Operation
ON Output 1 Trouble
S6 reserved
S7 reserved
S8 reserved
Status LEDs
Comms
Service
Network
Serial
Interface
DIP Switch
T
erminal Block