User Manual

Guide d’utilisation PIE1058 – indice A – Janvier 2023 - 28/72
Other
Settings
Programmable options (default settings in bold characters)
Language
Français | Español | Deutsch | Italiano | English
Time stamp
OFF | ON
Select “ON” if you want the date and time of the image capture imprinted on
every photo. The current temperature, moon phase, user set camera ID and GPS
coordinates (if the “GPS” parameter is set to ON) will also be imprinted on the
still photos.
Battery Type
Alkaline | Ni-MH (nickel-metal hydride)
The device will perform better and have better battery life if you select the type
of the batteries used in the camera.
Frequency
50Hz | 60Hz
An improper setting may cause the camera screen to flicker.
Cycle recording
OFF | ON
When the memory card will be full, the camera will continue to record
photos/videos by deleting the oldest photos/video.
Select “OFF” then press OK to deactivate the cycle recording function.
Password
OFF | ON
Select “ON” then press OK to enable password protection for your camera
(6 digits/letters).
Reset
No | Yes
Select “Yes” to reset the camera back to the factory default settings.
FW Update
Allows you to update the camera firmware.
QR Code
Allows you to view the QR code of the device if you need to pair it again with the
application.
About
This parameter shows the following information: Ver | IMEI | MCU | MOD
9. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and setting of the sun could
produce false triggers and overexposed images.
− If you’re covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false triggers due to temperature
and motions disturbances in front of the camera (especially in windy days).
− Check the power level of the batteries.
− Make sure the memory card is properly inserted and have sufficient available space.
− Verify time and date are correct.