Full Product Manual

09
08
HTTP://WWWNUMAXTOOLSCOM 1-888-669-5672
..
HTTP://WWWNUMAXTOOLSCOM 1-888-669-5672
..
MODEL: S50LSDH MODEL: S50LSDH
The tool may fire when it is first
connected to the air source. Always
connect the tool to the air source before
loading fasteners to prevent injury from
unintended cycling. Always make sure
the tool’s magazine is empty at the
beginning of each work session, before
connecting to air source.
WARNING:
!
Only use those fasteners recommended
for use with this tool. Fasteners not
identified for use with this tool by the tool
manufacturer can result in a risk of injury
to persons or tool damage when used in
this tool.
WARNING:
!
until it is locked into lock button. ( See figure 8 &
9.)
Unload the cleat nails or staples from the
magazine.(See figure 10 & 11.)
⒊
CHANGING THE FOOT PLATE
Disconnect the tool from the air source.
Empty the magazine completely.
Fire the tool into a piece of scrap wood to
ensure there is no compressed air or fasteners
left in the tool.
Set the tool on side to expose the four
screws (F).
Remove the four screws (F), then remove the
foot plate(G). (See figure 12)
Align the four screw holes in the replacement
foot plate with the four threaded mounting
holes.
Using the four screws you removed, secure the
replacement foot plate to the tool.
Ensure the correct foot plate is installed by firing
into a scrap piece of flooring and checking for
proper fastener placement.
its
located on the foot plate
The tool is equipped with a factory pre-installed 3/4
in. foot plate (G), and an additional uninstalled
in. foot plate .
To change the plate:
5/8
in. & 9/16
1.
2.
3.
3.
4.
5.
6.
7.
Disconnect the tool from the air source
whenever changing the foot plate.
Make sure there is no fastener in the
magazine before changing the foot plate.
WARNING:
!
UNLOADING CLEAT NAILS AND
STAPLES
Disconnect the tool from the air source.
Pull the pusher back to the end of magazine
⒈
⒉
Connect the tool to the air source.
Pull the pusher (D) back to the end of
magazine . Lock the pusher in the place by
using the lock button (E). (See figure 1 & 2.)
Insert a full clip of 1/2 in. crown staples into
magazine from the top. You can load up to the
90 pieces into the magazine.(See figure 5.)
Press the lock button(E), allow the pusher (D)
to slide forward and engage the staples. The
pusher (D) will stop when it rests against the
end of staples. (See figure 6 & 7)the
⒈
⒉
⒊
⒋
LOADING STAPLES
Lock
Button (E)
Staple
Pusher(D)
Lock Button (E)
Staple
L Cleat
Staples
Figure 4
L Cleat
Figure 3
L Cleat
Figure 6
Figure 7
Figure 9
Figure 8
Figure 10
Figure 11
Figure 5