Operation Manual

8
Edit Mappings
The earlier sections of this manual—Pads, Virtual Knobs (K1 – K4), and Accelerometers—
describe how to use the Edit Mappings panel to set the various MIDI messages for each
control. This panel has an additional feature, though, explained below.
Apply
The Apply feature lets you easily do either of the following:
• Copy a MIDI note number, MIDI CC number, or MIDI channel number to a group of
sequential controls of the same type (and on the same bank).
Examples:
o You could set all 16 pads' to a single MIDI channel.
o You could set Pads 8-16 to a single MIDI note number.
o You could set all virtual knobs to a single MIDI CC number.
• Assign MIDI note numbers, MIDI CC numbers, or MIDI channel numbers in ascending
order across a group of sequential controls of the same type (and on the same bank).
Examples:
o You could set Pad 1 to send MIDI Note 48, Pad 2 to send MIDI Note 49, Pad 3 to
send MIDI Note 50, etc.
o You could set Virtual Knobs K1, K2, K3, and K4 to send MIDI CCs 10, 11, 12, and
13, respectively.