Operation Manual

Virtual Knobs (K1 – K4)

To adjust the Virtual Knobs' MIDI messages:

1. Select a virtual knob (K1, K2, K3, or K4) by clicking it on the graphical interface. Its values

will appear in the Edit Mappings panel below.

2. Set the virtual knob's CC (Control Change) number by clicking the CC field and dragging

up or down. Alternatively, you can manually enter a value by typing it in.

3. Set the virtual knob's MIDI channel by clicking the Channel field and select the channel

number.

4. Set the virtual knob's mode by clicking the Mode drop-down menu and selecting the

mode:

• Absolute: The virtual knob will act as a 270º knob. It will send a value between 0 and

127, depending on its position (indicated by the ring of LEDs around it).

• Relative: The virtual knob will act as an "endless" 360º encoder. Turning it clockwise

or counter-clockwise will increase or decrease the software control's setting relative

to its current position. (Turning it clockwise will send a value of 0, and turning it

counter-clockwise will send a value of 127.)

5. Repeat Steps 1-4, if desired.