Operation Manual

5
Pads
To adjust the pads' MIDI messages:
1. Select a pad by clicking it on the graphical interface. Its values will appear in the Edit
Mappings panel below.
2. Set the pad's MIDI note number by clicking the Note field and dragging up or down.
Alternatively, you can manually enter a value by typing it in.
3. Set the pad's MIDI channel by clicking the Channel field and select the channel number.
4. Set the pad's mode by clicking the Mode drop-down menu and selecting the mode:
• Momentary: The pad will send its MIDI message for as long as you press and hold it
down. It will stop when you release it.
• Toggle: The pad will send its MIDI message continuously after you press it once. It
will stop when you press it again.
5. Set the pad's light color by clicking one from the palette on the right.
6. Repeat Steps 1-5, if desired.